6 to 4.1 nm), and the globular structure appears on the glass. Further increase of Au thickness leads to the increase of layer’s homogeneity and the globular structure being less pronounced as well as the surface roughness. The thermal annealing RXDX-101 clinical trial leads to a significant increase of surface roughness (Figure 3, second column). The globular structure is strongly amplified probably due to the local surface melting of gold nanoparticles during the thermal annealing process [16]. The dimensions of globular structures
are significantly higher in comparison to non-annealed ones. The surface morphology of the annealed Au with thickness of 35 nm is similar to those observed on glass substrate deposited by sputtering [15]. Similar changes in the morphology of the thin gold annealed structures and a sharp increase in surface roughness were observed on the samples annealed at 200°C for 20 h [17] and at 450°C for 2 h [18]. Figure 3 AFM images of the evaporated Au layers at different temperatures. AFM images of the evaporated Au layers on glass with room temperature
(first column, RT) and the same samples consequently annealed at 300°C (second column, annealed). The thicknesses of evaporated Au were 7, 18, and 35 nm. R a is the arithmetic mean surface roughness in nanometers. The rather different appearance of surface morphology was determined for evaporated Au deposited on see more glass already heated to 300°C (Figure 4). The gold layer of 7-nm thickness exhibited globular nanostructure with roughness of 3.8 nm. With increasing Au layer thickness, the globular nanostructure has a tendency to disappear. The electrically continuous nanolayer (35 nm) exhibits the lowest values of surface roughness (1.7 nm), the surface Sirolimus order pattern being similar to those obtained for sputtered Au [19]. The reason for such appearance should be within the formation of nanolayer and its nucleation. The electrical measurement revealed that the difference in thickness when the electrically continuous layer (Figure 1) is formed for as-evaporated and consequently
annealed layer and is minor in comparison to previously studied annealing of sputtered Au [5]. Therefore, we can suppose that the surface AZD6244 molecular weight diffusion of gold nanoparticles is suppressed when the layer is heated, which is connected with the different surface wettability when the substrate is heated. The influence of surface diffusion may take place also in the case of evaporation in the already heated glass (Figure 4). The appearance of globular structures caused by the evaporation of 7-nm Au is probably caused by the surface melting of evaporated Au nanoparticles during the deposition process. Even when the melting process takes place, the surface diffusion is suppressed and the structure has regular and homogeneous character.